No 3 (2012)


Reserves for increasing the competitiveness of enter-prises in construction industry

Kutlyeva G.M., Kuznetsov F.N., Kireev A.I.


Identification of reserves for the competitive advantage increase and application of research-based methods to usage of identified reserves is a priority at present. The main aim of this article is to propose methods for cost-reduction in construction.
RUDN Journal of Engineering Research. 2012;(3):5-10
pages 5-10 views

Some features of composition and genesis of terrigenous rocks of kolganskaya strata

Pavlinova N.V., Usova V.M.


The article is about Upper Devonian kolganskaya strata formed in delta front. Gamma-active benchs presented by clay deposits, were marked at the bottom of the kolganskaya strata, and its may be a good cap-rocks for the lower-lying rocks.
RUDN Journal of Engineering Research. 2012;(3):11-17
pages 11-17 views

The features of calculation movements and deformations of the surface at borehole to hydromining operations

Iofis M.A., Esina E.N.


The new calculation method of the surface movements and deformations in which for the first time prominent features of the developed space at borehole hydromining operations are considered is developed.
RUDN Journal of Engineering Research. 2012;(3):18-23
pages 18-23 views

Methodology for experimental studies of aquatic gas hydrates

Vorobiev A.E., Bolatova A.B., Baigalasova I.L.


Natural gas-hydrates are an unconventional source of energy. Potential reserves of hydrated gas are distributed all over the earth both on the land and offshore. Particular attention was given to the possible methodological support of research of gas hydrates.
RUDN Journal of Engineering Research. 2012;(3):24-35
pages 24-35 views

Emissions salt and gas at underground dissolution

Malyukov V.P.


The experimental investigation of the subsurface dissolution of rock salt from the salt and gas emissions, as well as determine themass-transfer coefficient that characterizes morphogenesis and speed of construction of underground workings to reserve tanks of hydrocarbons.
RUDN Journal of Engineering Research. 2012;(3):36-48
pages 36-48 views

The methodology to creat process flow diagrams and low-power sewage extraction complex strecture of layers with the use of beneficial species in the mine under-ground

Kushekov K.K.


Development of technology of efficient getting of weak and complicated structure seams with mine rock use.
RUDN Journal of Engineering Research. 2012;(3):49-56
pages 49-56 views

Fast reconstruction of the elementary particle tracks for the cosy-tof experiment

Borodina E.I.


Self-sufficient software package TOF-ONLINE for online visualization and preliminary data processing for experiments at COSY-TOF particle detector at COSY accelerator was developed. It automatically controls the detector elements functionality during data acquisition at the experiment, visualizes the detectors key parameters and creates geometrical reconstruction of the tracks of produced elementary particles in the context of the detector geometry. This work describes in details the algorithms of the final stage - the track reconstruction.
RUDN Journal of Engineering Research. 2012;(3):57-68
pages 57-68 views

Regulation of diesel by switching off - switching of cycles

Patrakhaltsev N.N., Grishin D.K., Emmill M.V., Kornev B.A.


There examined a problem of regulation of multicylinder diesel by variation of number of working cycles on regimes of low load and idle.
RUDN Journal of Engineering Research. 2012;(3):69-74
pages 69-74 views

Polarization of samples of the paint and varnish covering

Hodjakov A.A., Aby-Nidzdim R.K.


The mechanism of polarization of a lacquer coating is studied. It is established that polarization is caused by localization of charges, both in a thin blanket, and in covering volume. Electric resistance of samples has made 5.6 ⋅ 1017-5.6 ⋅ 1018 Ohm ⋅ cm, energy of activation responsible for a charge relaxation электрически active defects - 1.2 eV.
RUDN Journal of Engineering Research. 2012;(3):75-79
pages 75-79 views

Influence of the cooling liquid on process of cutting with ultrasonic vibrations

Kozochkin M.P., Solis-Pinargote N.V.


Results of experimental researches of process of cutting with application of tangential ultrasonic vibrations are stated. Features стружкообразования are shown at use of a cooling liquid, substantiations of the reasons of increase of cleanliness of processing and decrease in hardness of a removed shaving are given.
RUDN Journal of Engineering Research. 2012;(3):80-89
pages 80-89 views

A calculating plan for turbine profiles with a fixed thickness

Vinogradov L.V.


An article presents a method for designing a calculating plan for the turbine profiles with a fixed thickness of blade.
RUDN Journal of Engineering Research. 2012;(3):90-97
pages 90-97 views

The influence of the substrate temperature change character during the growth on the topology of the Ge/Si(100) film surface

Lunin L.S., Bavizhev M.D., Sysoev I.A., Lapin V.A., Kuleshov D.S., Malyavin F.F.


The possibility of roughness reducing of the Ge/Si (100) film using low-temperature layer of Ge (LT-Ge) has been investigated. It was shown that the substrate temperature change character during the growth process influences on the surface morphology of the grown Ge/LT-Ge/Si films. Samples were obtained by the method of molecular-beam epitaxy.
RUDN Journal of Engineering Research. 2012;(3):98-103
pages 98-103 views

A new integrated power plant with a small scale turbine for the Organic Rankine Cycle

Belozerov A., Kley M., Leschber Y., Rieger R., Shatalov I.K., Wiedmann M.


Combined heat and power (CHP or cogeneration) describes the simultaneous generation of electrical power and heat. CHP has been well established for medium and high power ranges (> 100 kW el. power). The Kompakte Dampf Turbine (KDT, meaning compact steam turbine) addresses the low-end of power generation (~2 kW el. power). The KDT is a highly integrated power plant of small dimensions able to use various heat sources. Its simple design promises a low-cost CHP for residential homes.
RUDN Journal of Engineering Research. 2012;(3):104-113
pages 104-113 views

Perfecting of technology of Foundation Construction in a Rammed Pit

Kharun Makhmud M.I., Kvartenko K.V.


Uniform and periodic covering of a surface rammer a layer of a lubricity liquid for reduction of friction of the soil and prevent soil from adhering to surface rammer produced by the spongy plate established in a cavity of the guide trunk and impregnated with lubricity liquid.
RUDN Journal of Engineering Research. 2012;(3):114-119
pages 114-119 views

The large deflections of the previously intense ideal plastic beams with the regional moments

Basov U.K., Monakhov I.A.


In the work up the technique of the decision of problems about the large deflections of beams from ideal hard-plastic material, with various kinds of fastening, for want of action of the asymmetrically distributed loads with allowance for of preliminary stretching-compression is developed. The developed technique is applied for research of the strained-deformed condition of beams, and also for calculation of a deflection of beams with allowance for of geometrical nonlinearity.
RUDN Journal of Engineering Research. 2012;(3):120-125
pages 120-125 views

Our autHors

- -.
RUDN Journal of Engineering Research. 2012;(3):126-128
pages 126-128 views

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies