Increase of efficiency cutting machining of cold-resistant steels by automatic calculation of the rational cutting modes

Cover Page

Cite item

Full Text

Abstract

Researches of influence of cutting parameters (speed of cutting, cutter feed and cutting depth ) on cutting power are considered at edge cutting machining of a cold-resistant steel 10GNB. On the basis of researches multifactorial models of firmness of the cutting tool are received. By the received results REZMET the technique and system of the automated calculation is developed for definition of optimum cutting parameters of cold-resistant steels.

About the authors

V A Rogov

Peoples' Friendship University of Russia

Email: vladimirrogov@yandex.ru
Кафедра технологии машиностроения,металлорежущих станков и инструментовИнженерный факультет; Российский университет дружбы народов; Peoples' Friendship University of Russia

A V Fomin

Peoples' Friendship University of Russia

Email: kafedra.tm.rudn@mail.ru
Кафедра технологии машиностроения,металлорежущих станков и инструментовИнженерный факультет; Российский университет дружбы народов; Peoples' Friendship University of Russia

References


Copyright (c) 2010 Рогов В.А., Фомин А.В.

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies