Vibrational investigation on toolholders of cutting tools in finish turning

Cover Page

Abstract


This paper investigates the effect of cutting tool construction, cutting conditions and overhang on the frequency during machining. The standard cutting tool and cutting tool with horizontal holes arranged in a chess-board pattern, made of hardened steel AISI 5140, were used. Three different workpieces made of aluminum, steel and cast iron were used. The experiments were carried out, based on single-factor experiment, on the lathe model 16K20VF1 (Russia). Results of experiments showed that the most significant parameter influencing the vibration is overhang variation. Besides, the optimum cutting conditions for the machined materials were found at different levels.

About the authors

V A Rogov

Peoples’ Friendship University of Russia

Email: vladimirrogov@yandex.ru
Engineering Faculty

S Ghorbani

Peoples’ Friendship University of Russia

Email: siamak_1997@yahoo.com
Engineering Faculty

References

Statistics

Views

Abstract - 150

PDF (Russian) - 161

Cited-By



Copyright (c) 2014 Рогов В.А., Горбани С.

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies