No 3 (2012)

Articles

THE RESEARCH OF STRAINED SILO STATE USING CAD

Markovich A.S., Pankratova G.E.

Abstract

The repeated failures and destructions of silо constructions are the result of inconsistency of existing methods of calculation. Using CAD, present article gives the analysis of strained state of round silo as the system of plain rings and thin-walled cylindrical cover. The results of calculations are appreciated critically and compared with the results, conducted before by the authors of experimental researches of silo stress strain behavior (SSB) on the model.
Structural Mechanics of Engineering Constructions and Buildings. 2012;(3):3-11
pages 3-11 views

PRESSURE OSCILLATIONS CHANGE IN CIRCULAR CYLINDRICAL SHELLS UNDER HIGH PRESSURE WAVES PROPAGATION ZONE LIMITATION

Rekach F.V.

Abstract

Analysis of pressure oscillations in a pipe line, limited by gate valves, closing nearly simultaneously under water withdrawal with constant pressure is given
Structural Mechanics of Engineering Constructions and Buildings. 2012;(3):12-14
pages 12-14 views

THE SETTLEMENT OF THE DAY SURFACE HETEROGENEOUS IN DEPTH HALF-SPACE AS THE RESULT OF UNSPECIFIED DISTRIBUTED LOAD

Hajiyev M.о., Draz V.M.

Abstract

The technique for the calculation of day surface settlement of half-space with linear increase of deformation module in correlation with depth with the use of piecewise linear approximation of the actual load is presented in this article. The numeric examples show that half space inhomogeneity decreases distributing capacity of the foundation in depth.
Structural Mechanics of Engineering Constructions and Buildings. 2012;(3):15-21
pages 15-21 views

DETERMINATION OF MAXIMAL BENDING OF THREE-CORNERED PLATES ON RESILIENT FOUNDATION WITH THE COMBINED SCOPE TERMS

Korobko V.I., Aktuganov A.A.

Abstract

Task of cross-bending of three-cornered plates with the combined scope terms (all possible combinations of the joint leaning and gesture-who jammings on sides) on resilient foundation, loaded with the equipartition on all area loading decides the method of interpolation on the coefficient of form (MIKF). For every combination of scope terms approximating functions are built for the count of two auxiliary coefficients, necessary for the choice of supporting decisions at the use of method of MIKF.
Structural Mechanics of Engineering Constructions and Buildings. 2012;(3):a21-30
pages a21-30 views

ON THE PROBLEM OF TWIRLED MOVEMENT OF VISCOUS LIQUID IN A PIPE

Ponomarev N.K.

Abstract

L.G. Loytsyansky put and solved system from four differential equations in private derivatives for the laminar twirled movement of viscous liquid in a pipe opening in space [1], filled with the same liquid. It found speeds of particles and pressure in the form of the ranks depending on longitudinal distance. Author considers other decision where there is a vurfovy proportion between three components of speed of a particle of liquid.
Structural Mechanics of Engineering Constructions and Buildings. 2012;(3):a30-38
pages a30-38 views

THE PERFECTION OF AN ANALYSIS METHOD OF SPATIAL SYSTEMS CONSISTING OF BOUND CLOSED CYLINDRICAL SHELLS

ShAGIVALEEV K.F., BUROV S.N.

Abstract

The way of optimization of calculation of the jointed closed cylindrical covers is offered. The essence of a method is stated on an example of the thin-walled spatial system, consisting of two closed barrel shells, one of which is subjected to internal pressure.
Structural Mechanics of Engineering Constructions and Buildings. 2012;(3):39-43
pages 39-43 views

MODELING OF THE STRESS-STRAIN STATEOF STRENGTHENED BEAM SYSTEMS

Ubaydulloye M.N., Serazutdinov M.N.

Abstract

In the paper, the variation method of calculation of the loaded beam systems strengthened in the ways of increase of section of elements and change of the constructive and settlement scheme of structures by installation of additional elements is presented. Taking into account plastic deformations of influence of repair and mounting stresses on degree of increase of load-carrying capacity of strengthened statically indeterminable structures was researched.
Structural Mechanics of Engineering Constructions and Buildings. 2012;(3):a43-51
pages a43-51 views

CRACK GROWTH RESISTANCE INCREASE OF REINFORCED CONCRETE DAMAGED BY CORROSION WITH REDUCTION OF PRESTRESSING

Baydin O.V.

Abstract

The method of quantity estimation of influence of reinforced concrete reduction on increase of resistance to crack formation of reinforced elements, damaged by corrosion is presented. The level of prestressing is taken into consideration also.
Structural Mechanics of Engineering Constructions and Buildings. 2012;(3):a51-57
pages a51-57 views

MISTAKES OF THE STANDARDS FOR THE DESIGN OF REINFORCED CONCRETE

Sanzharovsky R.S.

Abstract

The tests of theoretical and experimental models of standards for reinforced concrete have been made. The methods to correct mistakes in the hypotheses of the Eurocode have been defined.
Structural Mechanics of Engineering Constructions and Buildings. 2012;(3):a57-65
pages a57-65 views

MONOLITH HOLLOW FLOORS FOR DWELLING HOUSES

Glotov D.A., Loskutov I.S., Kantur O.V.

Abstract

This work summarizes monolith cellular floors design and construction within the site of a residential apartment house. The questions of engineering design, reinforcement and erection technology are considered. Attention is paid to the construction arrangement, workers training, technical and economic effectiveness of the approach compared to the similar procedures used for solid reinforced concrete floors.
Structural Mechanics of Engineering Constructions and Buildings. 2012;(3):66-71
pages 66-71 views

DETERMINATION OF MECHANICAL PROPERTIES OFCOMPOSITE MATERIAL "COPPER-NICKEL" BASED ON METAL POWDERS

Kohan L.S., Shulgin A.V., Novozhilov I.S.

Abstract

In this paper, a method of determining physical and mechanical properties of composite materials "copper-nickel" on the basis of metal powders "compositional method" was presented.
Structural Mechanics of Engineering Constructions and Buildings. 2012;(3):72-74
pages 72-74 views

THE MECHANISM OF REGULATION OF PRICES FOR THE PRODUCTS OFBUILDING COMPLEX IN THE MIDDLE EAST

Lork A.

Abstract

Автор рассматривает механизм регулирования цен на продукцию строительного комплекса в условиях Ближнего Востока. В ходе анализа этого механизма классифицируются цены, устанавливаются соответствующие формулы расчета, определяется порядок корректировки цен.
Structural Mechanics of Engineering Constructions and Buildings. 2012;(3):75-80
pages 75-80 views

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies