Calibration of stress meter

Cover Page

Abstract


The purpose of calibration stress meter is to determine what strain σ or elongation of the scale corresponds to one unit. It is more convenient to express the division value of the strain. The paper proposes to determine the actual price of the scale division of Automatic Meter strain (AID-4) in conjunction with a specific type of strain gage load cell calibration on the beam, and is an order of calculating the average price of a division on stresses σ and the relative deformation ε.
Instead of two resistance boxes and metrological service proposed, developed and used in the process control device efficiency (balancing and calibration).

About the authors

A Viktorovna Kalmakova

Peoples' Friendship University of Russia

Email: star-osta@mail.ru <mailto:star-osta@mail.ru>
Кафедра строительных конструкций и сооруженийИнженерный факультет; Российский университет дружбы народов; Peoples' Friendship University of Russia

P Dkhar

Peoples' Friendship University of Russia

Email: dkhar.prashanta@gmail.com <mailto:dkhar.prashanta@gmail.com>
Кафедра строительных конструкций и сооруженийИнженерный факультет; Российский университет дружбы народов; Peoples' Friendship University of Russia

O Evgen'evich Uzintsev

Moscow State Industrial University

Email: oleg@uzintsev.ru <mailto:oleg@uzintsev.ru>
Кафедра автоматики, информатики и систем управленияФакультет прикладной математики и математический физики; Московский государственный индустриальный университет; Moscow State Industrial University

References

Statistics

Views

Abstract - 215

PDF (Russian) - 389

Cited-By



Copyright (c) 2012 Калмакова А.В., Дхар П., Узинцев О.Е.

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies