egarding the calculation of the minimum friction stress in combined sewer pips

Cover Page

Abstract


Based on the M.I. Aleksejev's conclusions about the influence of the friction losses coefficient on the longitudinal and cross pulsations momentary rate in the fluid, was derived a formula for minimum friction stress definition on the walls of the combined sewer and drainage pips. The analysis of sediment grain-size composition of pollutants in combined sewer systems of European cities is given. Performed an analysis of correspondence between calculated friction stress values and friction losses coefficient values, that were obtained from measurements in combined sewer systems of Paris and Nantes. Maximum diameters of the particles of pollution which will be weighed by runoffs in compliance with the rules accepted for disposal networks in Europe and the U.S are determined.

About the authors

A V Kalinin

Togliatti State University

Кафедра водоснабжения и водоотведенияАрхитектурно-строительный институт; Тольяттинский государственный университет; Togliatti State University

References

Statistics

Views

Abstract - 180

PDF (Russian) - 68

Cited-By



Copyright (c) 2012 Калинин А.В.

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies